#HOW TO SETUP SNMP TRAP RECEIVER SOFTWARE#
Ideally import the AZETI-TRAP-MIB into the receiving software if you require OID translation.
![how to setup snmp trap receiver how to setup snmp trap receiver](https://blog.paessler.com/hs-fs/hubfs/PRTG-System-Health-Overall.jpg)
This setting becomes active when you select the enterpriseSpecific(6) option in the Generic identifier box. Select to specify an enterprise specific identifier for the SNMP trap. You must specify this option to filter based on a Specific identifier. This option has a numerical value of 5.ĮnterpriseSpecific(6): Select to filter based on an enterprise specific ID. This option has a numerical value of 4.ĮgpNeighborLoss(5): Select to filter for a lost connection to an EGP neighbor.
![how to setup snmp trap receiver how to setup snmp trap receiver](https://cdn.iphostmonitor.com/images/snmp-behind-nat-trap-setup.png)
This option has a numerical value of 3.ĪuthenticationFailure(4): Select to filter for a failed SNMP authentications to the network device. LinkUp(3): Select to filter for a re-established connection to the network device. LinkDown(2): Select to filter for a severed connection to the network device. WarmStart(1):Select to filter for a warm start of the network device. There are six options available:ĬoldStart(0): Select to filter for a cold start of the network device. Select to specify the generic identifier of the SNMP trap. Select to specify the enterprise identifier of the event raised by the device. Select to specify the IP address of the device where the event originates. If you select port 162, the Microsoft SNMP Trap Service must be disabled because it uses the same port when it runs. If you select the No dependency option, type the communication port number that will be monitored for SNMP traps. Select this option to monitor SNMP traps using a port rather than the Microsoft SNMP Trap Service. This service is only compatible with SNMP versions SNMPv1 and SNMPv2c.
![how to setup snmp trap receiver how to setup snmp trap receiver](https://lucamerello.files.wordpress.com/2015/02/snmp-trap.png)
Select this option to use the Microsoft SNMP Trap Service. Microsoft SNMP Trap Service (SNMPv1, SNMPv2c) Use the following information to configure the Monitor SNMP Trap activity. Generic or specific identifier of the device that you are monitoring Configuring the Monitor SNMP Trap Activityīefore you configure the Monitor SNMP Trap activity, you need to determine the following: Use the Monitor SNMP Trap activity to monitor a network device for critical errors, automatically create a trouble ticket, and perform level 1 diagnostics on the device. Using filters, you can invoke your runbooks according to the device that raised the event or the enterprise, generic, or specific identifiers of the SNMP trap.
![how to setup snmp trap receiver how to setup snmp trap receiver](https://cdn.comparitech.com/wp-content/uploads/2018/09/What-is-an-SNMP-Trap_.jpg)
The Monitor SNMP Trap activity waits for an event to occur either in the Microsoft SNMP Trap Service, or on a port that you specify.
#HOW TO SETUP SNMP TRAP RECEIVER UPGRADE#
This version of Orchestrator has reached the end of support, we recommend you to upgrade to Orchestrator 2019.